SSA Snatch Strap 75Tonne or 75000kgs 9m

Looking for a reliable and cost-effective solution for recovering heavy machinery? Look no further than Snatch Straps Australia! 75Tonne or 75000kgs Snatch Straps will suit SP Harvester and SP Boomsprays, Tractor and trailed boomsprays, smaller 4Wd and air-seeder combinations, single trailer truck units. Up to approximately 300-350HP pulling. Snatch Straps are the most cost-effective method of recovering heavy machinery. Snatch straps standard lengths are 9m/12m/15m/20m and 25 Meters. Photo colours are indicative only and may vary depending on current webbing available. For optimal safety, we recommend using 2 x 25000kgs shackles with our snatch straps, and 2 x 4750kgs shackles with our anti-recoil straps. Our range of shackles can be found on our website. Suggested shackle size for Snatch Strap = 2 x 25000kgs (25Tonne). Suggested shackle size for anti-recoil strap = 2 x 4750kgs (4.75Tonne). PLEASE NOTE: Snatch Straps can not be used for towing due to the 20%-30% stretch of the nylon. Attempting to tow will cause the strap to break at the stitching. If you require a tow strap, please see our tow strap range. Anti - Recoil Strap: All Snatch Strap Australia Snatch Straps include the anti-recoil safety strap. The anti-recoil safety straps are a superb product. In the event the breakage limit is reached, the anti-recoil strap eliminates the recoil of the of the snatch strap. Anchor points on vehicles are not always adequate to withstand the tonnage placed on them. Snatch Strap: SSA (Snatch Straps Australia) Recovery Snatch Straps are made from Australian Made 100% Nylon webbing, not Polyester. All webbing is sewn by our team that has over 40 years experience in this product. Eyes are sewn at each end of the strap with the Item Specifications and unique batch number attached. CAUTION: If the webbing strap is cut or damaged DO NOT USE, take it to your local stockist for assessment repair. All instructions are required to be perfectly followed, anti-recoil straps to be secured whenever supplied and common sense does need to be employed at all times. Highly Recommended: Bridle and Axel Straps. Bridle and Axle straps will assist the snatch strap to be evenly anchored on the stuck vehicle in 2 locations. This results in distribution of the load bearing on the vehicle and also allows a more balanced pull. This can also give an additional 1-2 meters of length. NEW MANDATORY SAFETY STANDARD - It is recommended that the minimum breaking strength of the strap should be between 2 and 3 times the vehicle's gross vehicle mass (GVM) and the strap must be suited to the (GVM) of the lighter of the two vehicles used in the recovery process. For full details on Snatch Strap Industry Guidelines are covered under the Consumer Goods (Motor Vehicle Recovery Straps) Safety Standard 2017