- Fast acting, non conductive cleaner
- Penetrates quickly and leaves no residue
- For use on electrical equipment, contacts, plastic & rubber
- Ideal for circuit boards, switches, printers, controls, electrical assemblies, copiers, tape heads & precision instruments
WD-40 Specialist® is an exciting range of products wearing the WD-40® shield you’ve come to rely on. These products have been specially designed for those more demanding jobs that just need to be done right.
WD-40 Specialist® Fast Drying Contact Cleaner is excellent for cleaning oil, dirt, flux residue and condensation from sensitive electronics and electrical equipment. It rapidly penetrates into hard to reach areas and dries quickly, without leaving any residue. This product can be used on electrical equipment, contacts, plastic and rubber.
Directions:
1. Isolate all power and allow any hot surfaces to cool.
2. Make sure all stored power is drained from the system.
3. Shake can well.
4. Spray directly onto the electronic device or circuit board to eliminate and remove any contaminants that may cause loss of electrical contact.
5. Tilt surface while cleaning and allow any excess cleaner to run off.
6. Allow product to dry completely and thoroughly.
7. Vent the system before restoring power.
