Feast Watson 4L Gloss Clear Slate and Pebble Sealer

A tough, clear, sealer and top coat designed to protect non-porous stone surfaces from weather, abrasion, food, oil, grease and household dirt. Feast Watson Slate & Pebble Sealer brings out the full colour and natural beauty of slate and stacked stone with a gloss finish.

Use on pathways, driveways, steps and front entrances. Ideal for enhancing pebbles in concrete and pebble aggregate.

Slate & Pebble Sealer is easily recoatable and under normal conditions will not crack or peel.
However, Slate and Pebble Sealer is not suitable for use on glazed or semi-glazed quarry tiles.

PREPARATION

Preparation is key before you start coating:

Ensure your surface is thoroughly clean and free from oil, grease, dirt and moss prior to applying.
Clean the surface with Feast Watson Floorclean as per the product instructions
For new concrete and aggregate pebbles:

Allow the surface to cure for approximately 28 days then treat surface with a 10% solution (dilute) of Hydrochloric Acid.
Apply Hydrochloric Acid using a brush or mop, allow the acid to remain on the surface for 15 minutes then flush off with clean water. 3. Allow the surface to dry completely before applying Slate and Pebble Sealer.

APPLICATION

Apply a minimum of two coats of Slate & Pebble Sealer using either a Feast Watson Floor Finish Applicator, brush, fine mohair or wool roller.

MAINTENANCE

Always check on your surface to look for any signs of loss of gloss or scratches. If an additional coat is required, clean using Feast Watson Floorclean. Apply one coat of Slate and Pebble Sealer as per application instructions.