Feast Watson 1L Gloss Wipe On Poly

A clear, silky smooth, oil based polyurethane finish that provides durable protection with classic hand-rubbed beauty. PREPARATION Before getting started, ensure the following: Fill nail holes, cracks and other defects with a Water Based Putty after applying the first coat of this product for accurate colour matching. With mineral turpentine, remove stains, dirt, wax, grease and oil. Using a suitable polish remover, remove any polish. Bare Timber If you are applying Wipe-on Poly to Bare Timber: Sand to a smooth surface. Remember to remove all sanding dust before coating. - For naturally oily timbers, seal the timber with Feast Watson Proofseal as per the directions prior to application. Previously Coated Timber If you are applying Wipe-on Poly to Previously Coated Timber: Sand back previously varnished surfaces to a dull finish. Remove all sanding dust before coating. Thoroughly clean the surface with Floorclean and allow to dry. Apply one coat to a small test area. Allow to dry for 6 hours. Press sticky tape firmly to the surface and pull off quickly. - If the coating comes off, sand back to bare timber. - If coating adheres well, sand the entire area with 180 - 240 grit paper for good adhesion, remove dust, then follow application instructions. APPLICATION Make sure to shake Mastertouch Wipe-on Poly container for one minute prior to use. How to apply Wipe-on Poly to Interior Timber: Apply a generous amount with a clean lint free cloth in the direction of the grain. Allow to dry for a minimum of 6 hours. - If you require additional coats, follow the above instructions. Remember that a light sand with 240 grit sand paper is recommended between coats. Looking to Stain? Apply Feast Watson Prooftint following label directions prior to the application of Wipe-on Poly. Allow Prooftint to dry the recommended period before applying Wipe-on Poly.