AEG 300W 125mm Random Orbital Sander
If you’re looking to refresh wooden furniture or surfaces, such as a deck, it’s likely you’ll need to sand the wood back at one point. If you're working with larger surface areas, a power sander can save you time and effort, transforming a lengthy job into an effective and efficient one!
If you’re not familiar with power sanders, fear not; we’ve uncovered the different types, how to fit the grit and how to use each type to best effect. Follow our simple guide for your next D.I.Y. sanding project.
A belt sander is used for sanding very rough surfaces or surfaces that need levelling or shaping. They are best for DIY projects like taking the top layer off hardwood floors, especially when the joins in the wood are uneven. They can only be used for flat surfaces.
Most sanders will come with a dust bag attachment, which are designed to extract the debris through the exhaust vents. This results in a cleaner work area and reduces the frequency in which the dust clogs the paper on the machine.
There are two types of power set-ups: battery and corded. Corded offers continuous power supply, a higher level of power and are lightweight. Battery-operated sanders are obviously more portable but are also quite capable of carrying a lot of power.
To insert the belt into a belt sander, release the lever, usually found on the side of the sander, and slide it onto the wheels. Press the lever closed to secure.
For orbital or detail sanders, the pads have a hook and loop back ( Velcro) – simply line up with the base and stick on. When you are ready to change grit, you simply peel it off and attach the next one.
When using any type of power sander, it’s safest to put on safety goggles, ear protection and wear a dust mask. These precautions will protect you from the wood dust that accumulates in the air as you sand.
The first thing to do with a belt sander is locate the tracking knob by turning over the sander so the front handle is resting on the table. Then, you’ll need to check the belt to determine which direction it needs to be tracked. To do this, revert the sander to its original position, turn it on and look to see what direction the belt needs to be tracked. If it needs to be changed, turn the knob clockwise to move the belt to the left, or counter clockwise to move towards the right.
After this, it's as simple as moving your sander with the grain of wood. Before applying it to the surface, turn it on and let it run for a few seconds to get it up to speed. Gently ease onto the surface, making long, even strokes along the grain.
Apply a steady pressure to ensure an even avoid pressing down too firmly as this can gouge the board. Stop and check your work as you go – the last thing you need is an uneven sanding job!
For the orbital or detail sander, the first thing to do is switch it on and let it rise to full speed. Then gently set it on the surface, applying gentle pressure as you move in the direction of the grain.
These types of sanders are designed to finish surfaces rather than create a shape so it’s important not to push too hard. Keep the base flush to the wood to avoid creating undulations in the surface.
Asbestos, lead-based paints and copper chromium arsenic (CCA) treated timber are health hazards you need to look out for when renovating older homes. These substances can easily be disturbed when renovating and exposure to them can cause a range of life-threatening diseases and conditions including cancer. For information on the dangers of asbestos, lead-based paint and CCA treated timber and tips for dealing with these materials contact your local council's Environmental Health Officer or visit our Health & Safety page.
When following our advice in our D.I.Y. videos, make sure you use all equipment, including PPE, safely by following the manufacturer’s instructions. Check that the equipment is suitable for the task and that PPE fits properly. If you are unsure, hire an expert to do the job or talk to a Bunnings Team Member.