- Kit includes: 18V F-RAPID 15GA DA Angled Brad Nailer, 18V 5Ah FORCE Battery and 18V 3.2A Single Port Charger
- Bump fire mode with 3-nail/second cycle rate
- F-RAPID brushless motor
- High-capacity magazine holds up to 110 15GA DA angled brad nails
- Dryfire lock-out mode reduces jams and damage to firing pin from dry shots
The AEG 18V F-RAPID 15GA DA Angled Brad Nailer delivers a fast and clean solution for securing cornices, skirting and other trim pieces. This Kit also comprises an 18V 5Ah FORCE Battery and 18V 3.2ACharger.
The Brad Nailer efficiently fires 15GA DA angled brad nails into softwoods and hardwoods, leaving behind consistent and clean nail holes for easy filling. Its brushless motor generates a 3-nail/sec fire rate in bump fire mode for enhanced proficiency onsite. Insert up to 110 15GA DA angled brad nails into the high-capacity magazine and take advantage of reduced downtime from reloads.
The Brad Nailer’s dryfire lock-out mode automatically engages to prevent damage to the firing pin from dry shots. This cordless model is 15% lighter than the previous AEG Brad Nailer (AFNDA18B-0) to reduce fatigue from working overhead and extended use. A smaller nose makes it easier to get into tight areas.
Don’t worry about relying on hoses, gas cartridges or air compressors. This cordless model only requires an AEG 18V battery for a power source and quick setup.
This Brad Nailer is part of AEG’s F-RAPID range of Nailers engineered for trade applications. F-RAPID technology combines a powerful brushless motor, high nail firing rate with low latency and large magazine capacities. These Nailers also harness powerful driving force to fire nails into hardwoods and various other materials. With no reliance on compressors or fuel, experience cheaper running costs and fewer maintenance requirements.
The 18V 5.0Ah FORCE Battery provides optimum power and runtime for all AEG 18V power tools. Its smart sync system delivers a power increase of up to 25%* and longer runtimes when used in tandem with FUSION tools. Smart electronics enable you to push your tools harder for longer with overheat and over-current protection.
The Charger is compatible with any AEG 18V Battery in your toolkit. Its detailed LED panel communicates charging status, temperature, and overall health of the battery.
*Compared to standard AEG 18V pro-lithium batteries.
AEG is a registered trademark used under license from AB Electrolux (publ).