Red Sea Reefato+ System

red sea reefato+ system the reefato+ is designed to maintain a stable salinity and water volume in a reef aquarium by automatically replenishing the water lost due to evaporation. In addition, the reefato+ provides two other critical aquarium health indicators: a fully featured on-line digital temperature monitor and a leak detector. the ec technology titanium probes detect the water levels that triggers the pump to be switched on and off to maintain a stable water level and salinity. fail-proof (solid-state ec technology) water level sensor, with built-in back-up pump-off probes located 2.5cm / 1” above the normal pump-off point. the full array of the reef-spec titanium probes gives an indication at all times of the actual water level relative to the sensor, which can be seen on the reefbeat app at all times. the temperature sensor integrated in the ato+ sensor has been pre-calibrated to give an accuracy of ±0.1°. the reefbeat app allows you to set a narrow “desired” temperature range, and a slightly wider “acceptable” range, that will be seen on-line in the reefbeat app and in the full temperature logs. In the event that the temperature goes outside the acceptable range you will get a notification to your smartphone. the detailed logs will show you the minimum, maximum and average temperatures at 15 minute intervals for the past 28 days. the highly sensitive, reef-spec leak detector with saltwater resistant titanium probes detects the full range of waters from rodi to seawater. if a leak is detected the ato auto-fill is immediately disabled, and after a few seconds to confirm that the leak persists, the controller sounds an optional audible alarm and sends a notification to your mo...