Icon Plastics 100 x 50 To 90mm Pull Down Rainwater Diverter

I/N: 4760078
Price correct as at Sun 16 Dec 2018 10:58:09pm
Add to Store Order
Products can be picked up or delivered. Your local store will contact you to confirm stock availability, delivery charges and organise payment.
Add to Cart
Confirm whether the customer will pick up their order or have it delivered. Contact the supplier to confirm stock availability. If applicable, please organise payment at this time.
Not all products available in all stores
Contact your nearest store for product information.

Special Order

Contact your nearest store to order

Product Description

The most user-friendly rainwater diversion system available.
No need to worry about catching and moving rainwater. Install the Flap Diverter and divert rainwater to where you want, when you want. Can be fitted at any height on a downpipe to divert water into a tank or onto a garden bed.
Sturdy RPVC construction means low maintenance and simple cleaning. RPVC can be painted to match the colour of any downpipe system. The Flap Diverter is ready for use with 100x50mm rectangular downpipe, and each Flap Diverter comes with two bonus adaptors to fit to 90mm diameter downpipe. If necessary,
carefully select the correct adapters so the Flap Diverter will attach properly to your downpipes. If attaching to downpipe smaller than 90mm diameter the multi-adapter can be cut to size. If fitting to rectangular downpipe different to 100mm x 50mm use one
of Icon Plastics’ rectangular adapters.

  • Allows rainwater to be diverted from anywhere on any downpipe
  • Each Flap Diverter comes packaged with two bonus adapters to suit 90mm diameter pipe.
  • Simple installation – Measure, mark and cut the downpipe, then fit the Flap Diverter.

Product Details

Model Name
Flap Rainwater Diverter
Model Number
Product Dimensions (mm)
W:120 H:350 L:98
Package Dimensions (mm)
W:360 H:610 L:590

Product Downloads

Installation Guide

Additional Info

Installation Info

Locate the most suitable position for the Flap Diverter.
Remove any clips or ties holding the downpipe in place.
If using the Flap Diverter without adaptors, measure and mark 225mm of downpipe.
If using adapters, measure and mark measure and mark 285mm.
Cut and remove the required length of downpipe.
If using adapters, fit them to the ends of the downpipe with the Icon logo facing forward.
Slide the top of the Flap Diverter over the top section of downpipe or adapter, pushing it
up to allow the diverter to fit into the gap, then lower it into position so the groove at the
bottom sits on the top edge of the downpipe or adaptor.
When fitting to metal downpipe seal the joins with Silicone plumber’s sealant.
Return the downpipe to position and tighten the clips or ties.

Top of the content