A flexible marine grade timber varnish with high gloss designed to withstand the rigours of sun, water and harsh outdoor treatment.



PREPARATION



New Timber



How to prepare new timber:



Allow new timber to adapt and adjust to the climate in its final position for 4-6 weeks.

Prepare exterior timber for coating with Feast Watson Woodclean. Sand to a smooth surface. Remember to remove all sanding dust before coating!

Weathered Timber



How to prepare Weathered Timber:



Prepare your exterior weathered or grey timber by cleaning thoroughly with Feast Watson Woodclean.

Sand to a smooth surface and remove all sanding dust before coating.

Previously Coated Timber



How to prepare Previously Coated Timber:



Previously coated surfaces need to be taken back to bare timber by sanding timber to a smooth surface.
Remember to remove all sanding dust before coating!



APPLICATION



Feast Watson Spar Marine Varnish should be stirred thoroughly before and during application with a flat blade stirrer. Take care not to introduce bubbles!

Using a brush, roller or spray, apply Spar Marine Varnish.

- Are you using a spray? If so, the Spar Marine Varnish may be thinned by using 10% mineral turpentine.

- Are you using a roller? If so, use a short nap (5mm) mohair roller. Ensure edges and end grain are fully coated.

Make sure to apply minimum three coats.
- Four or more coats may be applied for extra durability to withstand extreme exposure or when the coating has been thinned.

Allow 12 hours drying between coats. Sand lightly between coats.

- The final coat should be applied within 30 hours of the previous coat to ensure timber is protected.

NOTE: Do NOT apply in temperatures under 10 C or above 35 C or when rain or heavy dew is expected within the coating dry time.



MAINTENANCE



As always, regularly monitor the surface for signs of colour loss or surface defects.
Reapply Spar Marine as the timber changes colour or when water repellency is lost due to weathering.

When required, lightly sand the surface and remove dust. Recoat with additional coats of Feast Watson Spar Marine Varnish as per application instructions.