Surface should be clean, dry and free from contaminants such as rust, oil, grease, dirt and salt. Wipe surface with Mineral Turps or General
Purpose Thinner. Thoroughly sand new metal and lightly sand previously painted surfaces to ensure maximum adhesion. Remove loose rust and
flaking paint with a wire brush, scraper or mechanical sander. For best results, always remove rust back to bare metal. For superior protection
and adhesion on mild steel surfaces it is recommended to prime with the appropriate Dy-Mark Primer. For non-ferrous metals such as
aluminium and alloys, ZINCALUME®, stainless steel, use Dy-Mark Etch Primer.
Before spraying, cover surrounding areas to protect from overspray. Shake can for at least 45 seconds AFTER the mixing ball
begins to rattle. Shake the can occasionally during use. Hold the can upright approximately 20-25cm from the surface.
Spray with a smooth sweeping motion. To prevent paint from sagging, apply several light mist coats rather than one heavy
Adjust nozzle to achieve desired spray pattern. Use horizontal setting to spray up and down and the vertical stetting to spray
left to right.