How To Make Hanging Pipe Planters

View the video

Project Overview

Add a touch of flair to any space with these Hanging Pipe Planters made from tough, readily available PVC pipe and a dash of imagination. Adult supervision is recommended and always keep children away from hand and power tools.

Materials

PVE Bend Pipe 100mm
PVC Bolted Trap Pipe 100mm
PVCE Pipe 1m
Gold Jack Chain 1.6 x 3m
Revolution Copper Hammer Finish Spray Paint
Cup Brass Hooks 25mm
Assorted Plants

Tools

Cordless Drill
Sanding Block
Builders Pencil
Measuring Tape
Pre Drill Bits
Jigsaws
Potting Mix
Continue to Step-by-step instructions.

Step by Step Instructions

1 Drill
2 Outline
3 Cut outline
4 Fit
5 Installing hooks
6 Screw
7 Spray
8 Plant
9 Attach chains
  • Step 1. Drill

    Drill drainage holes along the underside of your pipe.
  • Step 2. Outline

    Turn pipe over and draw a cutout outline.
  • Step 3. Cut outline

    Using a jigsaw cut out your outline.

    Handy hint: pre-drill a few holes in succession to allow blade of jigsaw to cut from the middle of the pipe.

  • Step 4. Fit

    Fit elbow to one end of pipe. Place end cap at opposite end.

    Handy hint: place a little glue on the sleeve of the pipe should for a more permanent fixing.

  • Step 5. Installing hooks

    Pre drill one hole at both ends of the pipe for your eye hooks to be installed. Ensure your drill bit is slightly smaller than your hook.
  • Step 6. Screw

    Screw brass eye hooks into pipe.
  • Step 7. Spray

    Spray the entire pipe including both ends with Revolution spray praint. This contains a primer and paint finish in one.
  • Step 8. Plant

    Fill the pipe with potting mix and plant your selection of plants.
  • Step 9. Attach chains

    Attach two identical chains to your eye hooks and suspend from overhead.
Top of the content